JOHNSON CONTROLS
21
FORM 155.32-ICOM1.EN.GB
ISSUE DATE: 10/13/2017
3
SECTION 3 – HANDLING, STORAGE, INSTALLATION AND REASSEMBLY
FIGURE 3 - WARNING
Rigging and liing should only be done by
a professional rigger in accordance with a
written rigging and liing plan. e most
appropriate rigging and liing method
will depend on job specic factors, such
as the rigging equipment available and
site needs. erefore, a professional rig-
ger must determine the rigging and liing
method to be used, and it is beyond the
scope of this manual to specify rigging and
liing details.
This chiller-heater is for air conditioning or a cooling
manufacturing process. Transport, store, and use this
chiller-heater under the following conditions:
Installation location: Indoor, non-explosion area
Ambient temperature: 10 ~ 40°C
Humidity: 10 ~ 90% (RH%)
Altitude: 1000 m or lower
If the plant room will ever get below 10°C, you must
have the cold ambient option.
To Next Page
Loading...
Need help?
General
