York YLUA0078 - PRODUCT IDENTIFICATION NUMBER (PIN) (CON’T)

JOHNSON CONTROLS
24
FORM 150.73-NM1
ISSUE DATE: 09/04/2020
SECTION 2 – PRODUCT DESCRIPTION
PRODUCT IDENTIFICATION NUMBER (PIN) (CON’T)
FEATURE FEATURE DESCRIPTION OPTION OPTION DESCRIPTION
UNIT Unit Designator (PIN 9)
H High E󰀩ciency
S Standard E󰀩ciency
Y High E󰀩ciency (Round Tube)
Z Standard E󰀩ciency (Round Tube)
REF Refrigerant (PIN 10) E R-410A
VOLTS Voltage (PIN 11 and 12)
17 200/3/60
28 230/3/60
40 380/3/60
46 460/3/60
50 380-415/3/50
58 575/3/60
STARTER Starter (PIN 13) X Across the Line starter
DESIGN Design Series (PIN 14)
A Design Series A (MicroChannel)
B Design Series B (Tube and Fin)
DEV Development Level (PIN 15) A Development Level A
POWER
Power Field (PIN 16 and 17)
SX SP Supply TB
SD SP NF Disconnect Switch
BX SP Circuit Breaker w/ Lockable Handle
DB SP NF Disc Switch w/Ind Sys CB
TRANS Cntrl Transformer (PIN 18)
X No Control Transformer Required
T Control Transformer Required
Q Special Control Transformer Required
PFC Power Factor Capacitor (19)
X No Power Capacitor required
C Power Capacitor required
Q Special Power Capacitor required
AMB Ambient Kits (PIN 20)
H High Ambient Kit (Standard) (factory)
AG
High Ambient Kit required (eld)Both Low/High Ambient Kit
required (factory)
Q Special Ambient Kit required
BAS Bas Reset/O󰀨set (PIN 21)
T BAS/EMS Reset/O󰀨set (standard)required
Q Special BAS Reset/O󰀨set required
LCD Language (PIN 22) X English
RDOUT Readout Kits (PIN 23)
RX Discharge Pressure Readout (standard)X
Q Special Quote
SAFETY Safety Codes (PIN 24) L N American Safety Code (cUL/cETL)
SENSOR Suction Temp (PIN 25)
XT Suction Temp Readout (standard)X
Q Special Quote
PUMP Motor Current Module (PIN 26) C Motor Current Module (standard)
REMOTE Remote Panel (PIN 27)
X X
Q Special Quote
SEQ Sequence Kit (PIN 28)
X X
Q Special Quote
TEMP Leaving Water Temp(29,30)
NUM Leaving Water Temp = {TEMP/NUM} degrees
QQ Special LWT requirements