York YLUA0078 - Page 58

JOHNSON CONTROLS
58
FORM 150.73-NM1
ISSUE DATE: 09/04/2020
SECTION 5 – TECHNICAL DATA
GENERAL
19
For optional hydro kit. Heater -EPH is tted and wired as shown. On single pump -KP1, -QMMSP1 and -MP1 are
tted and wired as shown. On two pump hydro kits -KP2, -QMMSP2 and -MP2 are also tted and wired as shown.
20 Current measurement option wired as show.
21 Only tted on systems with single speed fans.
22 Only tted on systems with two speed fans.
23 Optional compressor manual motors starters (standard on CE units).
24 See sheet 3 of connection diagram for power input options.
25 Alternate connections shown for di󰀨erent two speed motor types.
26 Only tted on systems with a maximum of 4 fans.
27 220/230V units require a separate fuse for units w/4 or more fans per system.
28 Low ambient kit -FSC for fan -MF1 is only tted on systems with less than 4 fans.
29 Only tted on YLUA0098.
30 Only tted on YLUA0095, 0098 and 0148.
31 Input dual point circuit breaker option replaces input terminal block.
32 Field installed on remote evaporator units.
33 Fitted on units with single phase motors only
34 Fitted on units with low ambient option only
35 Only tted on units with an acoustic kit
36 Only tted on heat recovery units
37 Only tted on condensing units
38 Omitted on condensing units
Electrical Notes And Legend (Continued)
035-21966-101 REVG