Application Deployment
128
8. Press the Number 1 button. The System Update installs and then the device returns to the Recovery
screen.
9. Press the Number 1 button to reboot the device.
Using ADB
To perform an Enterprise Reset using ADB:
1. Connect the device to the Rugged Charge/USB cable.
2. Connect the cable to the host computer.
3. On the device, swipe down from the Status bar to open the Quick Access panel and then touch .
4. Touch System > Developer options.
5. Slide the switch to the ON position.
6. Touch USB Debugging. A check appears in the check box. The Allow USB debugging? dialog box
appears.
7. Touch OK.
8. On the host computer, open a command prompt window and type:
adbdevices.
The following displays:
Listofdevicesattached
XXXXXXXXXXXXXXXdevice
(where XXXXXXXXXXXXXXX is the device number).
NOTE: If device number does not appear, ensure that ADB drivers are installed properly.
9. Type:
adbrebootrecovery
10.Press Enter. The System Recovery screen appears.
11.Press the Number 1 and Number 2 buttons to navigate to apply from adb.
12.On the host computer command prompt window type:
adbsideload<file>
where: <file> = the path and filename of the zip file.
13.Press Enter. The Enterprise Reset package installs and then the Recovery screen appears.
Performing a Factory Reset
A Factory Reset erases all data in the /data and /enterprise partitions in internal storage and clears all
device settings. A Factory Reset returns the device to the last installed operating system image. To revert to a
previous operating system version, re-install that operating system image. See Performing a System Update
on page 125 for more information.
Downloading the Factory Reset Package
To download the Factory Reset package:
To Next Page
Loading...