Zebra DS4308 Reference Guide

Standard Default Parameters A - 3
Software Handshaking None 7-14
Host Serial Response Time-out 2 Sec 7-16
RTS Line State Low RTS 7-17
Beep on <BEL> Disable 7-17
Intercharacter Delay 0 msec 7-18
Nixdorf Beep/LED Options Normal Operation 7-19
Ignore Unknown Characters Send Bar Code 7-19
USB Host Parameters
USB Device Type HID Keyboard Emulation 8-4
USB Country Keyboard Types
(Country Codes)
North American 8-6
USB Keystroke Delay No Delay 8-8
USB CAPS Lock Override Disable 8-8
USB Ignore Unknown Characters Enable 8-9
Emulate Keypad Disable 8-9
Emulate Keypad with Leading Zero Disable 8-10
USB Keyboard FN1 Substitution Disable 8-10
Function Key Mapping Disable 8-11
Simulated Caps Lock Disable 8-11
Convert Case No Case Conversion 8-12
USB Static CDC Enable 8-12
IBM 468X/469X Host Parameters
Port Address None Selected 9-4
Convert Unknown to Code 39 Disable 9-5
Wand Emulation Host Parameters
Wand Emulation Host Types Symbol OmniLink Interface
Controller
1
10-4
Leading Margin 80 msec 10-5
Polarity Bar High/Margin Low 10-6
Table A-1 Standard Default Parameters Table (Continued)
Parameter
Parameter
Number
Default
Page
Number
1
User selection is required to configure this interface and this is the most common selection.

Zebra DS4308 Specifications

General

Sealing	IP42
Connectivity	USB, RS232, Keyboard Wedge, TGCS (IBM) 46XX over RS485
Decode Capability	1D, 2D, PDF417
Drop Specification	Withstands multiple 1.5 m (5 ft) drops to concrete
Operating Temperature	32° to 104° F/0° to 40° C
Storage Temperature	-40° to 158° F/-40° to 70° C
Humidity	5% to 95% (non-condensing)
Weight	5.7 oz./161.9 g
Dimensions	6.5 in. H x 2.6 in. W x 3.6 in. D 16.5 cm H x 6.6 cm W x 9.1 cm D