Zebra LS2208 Reference Guide

Maintenance and Technical Specifications 3 - 3
Scanned data is incorrectly
displayed on the host.
Scanner is not programmed to
work with the host. Check
scanner host type parameters
or editing options.
Be sure proper host is selected. (See the
host chapter for your scanner.)
For RS-232, ensure the scanner’s
communication parameters match the host’s
settings.
For a USB HID keyboard or a keyboard
wedge configuration, ensure the system is
programmed for the correct keyboard type
and language, and the CAPS LOCK key is in
the correct state.
Be sure editing options (e.g., ADF, UPC-E to
UPC-A Conversion) are properly
programmed.
Table 3-1 Troubleshooting (continued)
Problem Possible Causes Possible Solutions
NOTE If after performing these checks the symbol still does not scan, contact your distributor or support. See
page xv for contact information.

Zebra LS2208 Specifications

General

Scan Technology	Laser
Connectivity	Wired
Scan Pattern	Single line
Drop Specification	Withstands multiple 5 ft./1.5 m drops to concrete
Scanner Type	Handheld
Scan Rate	100 scans per second
Humidity	5% to 95% (non-condensing)
Interface Options	USB, RS-232, Keyboard Wedge
Decode Capability	1D barcodes
Dimensions	15.2 cm H x 6.3 cm W x 8.4 cm D
Weight	146 g
Operating Temperature	0°C to 50°C
Resolution	5 mil
Supported Barcodes	UPC/EAN, Code 39, Code 128, GS1 DataBar
Storage Temperature	-40°C to 70°C