RS-232 Interface 6 - 3
RS-232 Default Parameters
Table 6-1 lists the defaults for RS-232 host parameters. To change any option, scan the appropriate bar code(s)
provided in the Parameter Descriptions section beginning on page 6-4.
NOTE See Appendix A, Standard Default Parameters for all user preferences, hosts, symbologies, and
miscellaneous default parameters.
Table 6-1
RS-232 Host Default Table
Parameter Default Page Number
RS-232 Host Parameters
RS-232 Host Types
Standard
1
6-6
Baud Rate 9600
6-8
Parity Type None
6-10
Stop Bit Select 1 Stop Bit
6-12
Data Bits 8-Bit
6-12
Check Receive Errors Enable
6-13
Hardware Handshaking None
6-14
Software Handshaking None
6-16
Host Serial Response Time-out 2 Sec
6-18
RTS Line State Low RTS
6-19
Beep on <BEL> Disable
6-19
Intercharacter Delay 0 msec
6-20
Nixdorf Beep/LED Options Normal Operation
6-21
Ignore Unknown Characters Send Bar Code
6-21
1
User selection is required to configure this interface and this is the most common selection.
To Next Page
Loading...
