Zebra LS2208 Reference Guide

6 - 12 LS2208 Product Reference Guide
Stop Bit Select
The stop bit(s) at the end of each transmitted character marks the end of transmission of one character and
prepares the receiving device for the next character in the serial data stream. Select the number of stop bits (one or
two) depending on the number the receiving terminal/host is programmed to accommodate.
*1 Stop Bit
2 Stop Bits
Data Bits
This parameter allows the scanner to interface with devices requiring a 7-bit or 8-bit ASCII protocol.
7-Bit
*8-Bit

Zebra LS2208 Specifications

General

Brand	Zebra
Model	LS2208
Category	Scanner
Language	English