123
Printer Configuration and Adjustment
Calibrate the Ribbon and Media Sensors
10/7/16 ZT410 RFID Printer for Silverline Media User Guide P1089083-001
5. Pull the media into the printer so that only the backing is between the media sensors.
6. Remove the ribbon (if used).
7. Rotate the printhead-open lever downward until it locks the printhead in place.
8. Press PAUSE to begin the media calibration process.
•The PAUSE light turns off.
•The SUPPLIES light flashes.
• The control panel displays:
MEDIA/RIBBON CAL
CALIBRATING
PLEASE WAIT
To Next Page
Loading...