61
Printer Setup and Operation
Load Silverline Media and Calibrate the Printer
10/7/16 ZT410 RFID Printer for Silverline Media User Guide P1089083-001
Load Silverline Media and Calibrate the Printer
1. Open the printhead, and then load the Silverline media and Zebra 5095 resin-based ribbon.
For specific loading instructions, see Instructions for Loading Media on page 63 or
Instructions for Loading Ribbon on page 68.
2. Position the adjustable transmissive media sensor, so that the visible red LED shines on
the gap between the labels.
(View: printhead open, looking down the throat of the printer.)
3. Close the printhead, and then press the PAUSE button to enable printing.
The printer calibrates. If the calibration fails or if the printer displays a media error,
perform a manual media and ribbon calibration. (For instructions, see the calibration video
or Calibrate the Ribbon and Media Sensors on page 121.)
4. On the printer’s control panel, press LEFT SELECT to go to the Home menu.
5. Press the RIGHT ARROW until you reach the RFID menu.
6. Press OK to enter the RFID menu.
7. Press the LEFT ARROW or RIGHT ARROW until you reach RFID CALIBRATE.
8. Press the RIGHT SELECT button to begin the RFID calibration process.
The printer determines the optimal read/write power and antenna location to use for your
tags. For additional information about these settings, find the transponder information for
your printer at http://www.zebra.com/transponders.
To Next Page
Loading...