Troubleshooting
Meaning of Indicator Lights
140
P1089083-001 ZT410 RFID Printer for Silverline Media User Guide 10/7/16
Meaning of Indicator Lights
The indicator lights on the control panel show the current status of the printer (Table 14).
Table 14 • Status of Printer As Shown by Indicator Lights
STATUS light steady green (other lights steady yellow for
2 seconds during printer power-up)
The printer is ready.
PAUSE light steady yellow.
The printer is paused.
STATUS light steady red
SUPPLIES light steady red
The media supply is out. The printer needs attention and
cannot continue without user intervention.
STATUS light steady red
SUPPLIES light flashing red
The ribbon supply is out. The printer needs attention and
cannot continue without user intervention.
STATUS light steady yellow
SUPPLIES light flashing yellow
The printer is in Direct Thermal mode, which does not
require ribbon; however, ribbon is installed in the printer.
STATUS light steady red
PAUSE light steady yellow
The printhead is open. The printer needs attention and
cannot continue without user intervention.
STATUS light steady yellow
The printhead is over temperature.
Caution • The printhead may be hot and could
cause severe burns. Allow the printhead to cool.
STATUS light flashing yellow
This indicator light flashing indicates one of the following:
• The printhead is under temperature.
• The power supply is over temperature.
• The main logic board (MLB) is over temperature.
STATUS light steady red
PAUSE light steady red
DATA light steady red
The printhead was replaced with one that is not a genuine
Zebra™ printhead. Install a genuine Zebra™ printhead to
continue.
To Next Page
Loading...