33
Printer Setup and Operation
Install the Printer Driver and Connect the Printer to the Computer—USB
10/7/16 ZT410 RFID Printer for Silverline Media User Guide P1089083-001
Connect a Computer to the Printer’s USB Port
Complete the steps in this section only after you have installed the Zebra Setup Utilities
program. If necessary, complete the steps in Install Zebra Setup Utilities on page 24 before
continuing.
To connect the printer to your computer by USB, complete these steps:
Running the System Prepare Wizard
If you are at the Zebra Setup Utilities screen, you do not need to complete this section.
Continue with Connecting the printer to a USB port on your computer on page 34.
The first time that you install the Zebra Setup Utilities program and printer drivers, you are
prompted to follow the System Prepare Wizard.
Figure 7 • System Prepare Wizard
Important • You must install the Zebra Setup Utilities program before connecting the printer
to your computer. Your computer will not install the correct printer drivers if you connect the
printer to it without the Zebra Setup Utilities program.
Caution • Ensure that the printer power is off (O) before connecting data communications
cables. Connecting a data communications cable while the power is on (
I) may damage the
printer.
To Next Page
Loading...