Routine Maintenance
Cleaning Schedule and Procedures—Clean the Printhead and Platen Roller
136
P1089083-001 ZT410 RFID Printer for Silverline Media User Guide 10/7/16
Clean the Printhead and Platen Roller
Inconsistent print quality, such as voids in the bar code or graphics, may indicate a dirty
printhead. For the recommended cleaning schedule, see Table 13 on page 134.
To clean the printhead and platen roller, complete these steps:
1. Raise the media door.
2.
3.
Remove the ribbon (if used) and the media.
Caution • While performing any tasks near an open printhead, remove all rings, watches,
hanging necklaces, identification badges, or other metallic objects that could touch the
printhead. You are not required to turn off the printer power when working near an open
printhead, but Zebra recommends it as a precaution. If you turn off the power, you will lose
all temporary settings, such as label formats, and you must reload them before you resume
printing.
Caution • The printhead may be hot and could cause severe burns. Allow the printhead
to cool.
Caution • Before touching the printhead assembly, discharge any built-up static electricity
by touching the metal printer frame or by using an antistatic wriststrap and mat.
Caution • The printhead may be hot and could cause severe burns. Allow the
printhead to cool.
Open the printhead assembly by rotating the printhead-open lever.
To Next Page
Loading...