137
Routine Maintenance
Cleaning Schedule and Procedures—Clean the Printhead and Platen Roller
10/7/16 ZT410 RFID Printer for Silverline Media User Guide P1089083-001
4.
5.
Rotate the printhead-open lever downward until it locks the printhead in place over the
cleaning film.
6. Slowly pull the full length of the film through the print mechanism.
If pulling the strip through once or twice does not clean the print mechanism adequately,
you may gently rub the strip back and forth over the area to try to dislodge any residue.
Discard the strip if residue buildup or other contamination is apparent.
7. Reload the ribbon (if used) and the media. For instructions, see Instructions for Loading
Ribbon on page 68 or Instructions for Loading Media on page 63.
8. Rotate the printhead-open lever downward until it locks the printhead in place.
9. Close the media door.
10. Press PAUSE to exit pause mode and enable printing.
The printer may perform a label calibration or feed a label, depending on your settings.
11. Print labels and inspect for improved print quality. If quality has not improved, contact
Technical Support at http://www.zebra.com/support.
Caution • Do not use liquids to clean any part of this printer, especially the printhead.
Zebra is not responsible for damage caused by the use of cleaning fluids on this
printer.
Position the Save-a-Printhead film in the print path. Place the film’s glossy side down
and away from the printhead. (Keep the film’s matte side up.)
To Next Page
Loading...