Zebra Silverline ZT410 - Sensor Settings

Printer Configuration and Adjustment
Adjust Printer Settings—Sensor Settings
114
P1089083-001 ZT410 RFID Printer for Silverline Media User Guide 10/7/16
Sensor Settings
Table 9 • Sensor Settings
SENSOR TYPE
Sensor Type Select the media sensor that is appropriate for the media that you are using. The
reflective sensor typically is used only for black mark media. The transmissive sensor
typically is used for other media types.
User menu item:
Main Menu >
SENSORS
Accepted values:
• TRANSMISSIVE
• REFLECTIVE
Related ZPL command(s):
^JS
SGD command used:
device.sensor_select
Printer web page: View and Modify Printer Settings > Media Setup
LABEL SENSOR
Label Sensor Set the sensitivity of the label sensor.
Important • This value is set during sensor calibration. Do not change this
setting unless you are told to do so by Zebra Technical Support or by an
authorized service technician.
User menu item:
Main Menu >
SENSORS
Accepted values:
0 to 255
SGD command used:
ezpl.label_sensor
Printer web page: View and Modify Printer Settings > Calibration