63
Printer Setup and Operation
Load Silverline Media and Calibrate the Printer
10/7/16 ZT410 RFID Printer for Silverline Media User Guide P1089083-001
Instructions for Loading Media
Use the instructions in this section for loading Silverline media.
Figure 13 • Silverline Media in Tear-Off Mode
To load media, complete these steps:
1. Raise the media door.
Caution • While performing any tasks near an open printhead, remove all rings, watches,
hanging necklaces, identification badges, or other metallic objects that could touch the
printhead. You are not required to turn off the printer power when working near an open
printhead, but Zebra recommends it as a precaution. If you turn off the power, you will lose
all temporary settings, such as label formats, and you must reload them before you resume
printing.
Note • In some of the drawings that follow, the printer is shown without a ribbon system to
give you a better view of the components involved in media loading.
To Next Page
Loading...