Zebra Silverline ZT410 - Lower the Media Sensor and Ribbon Strip Plate (if necessary)

Printer Setup and Operation
Lower the Media Sensor and Ribbon Strip Plate (if necessary)
58
P1089083-001 ZT410 RFID Printer for Silverline Media User Guide 10/7/16
Lower the Media Sensor
and Ribbon Strip Plate (if necessary)
1. Loosen the 3 mm Allen screw located directly underneath the adjustable transmissive
media sensor.
2. With your fingers, grab the lower half of the transmissive media sensor housing (near the
mainframe) and pull it downward as far as it will go, and then re-tighten the screw. This
sets the media sensor housing to accommodate the thickest media.
Note • Each ZT410 RFID printer with the Silverline Solution should leave the
manufacturing plant with both the media sensor and the ribbon strip plate in the lowest
position. If this is not the case, complete the instructions in this section.