77
Printer Configuration and Adjustment
Adjust Printer Settings—Print Settings
10/7/16 ZT410 RFID Printer for Silverline Media User Guide P1089083-001
Print Settings
Table 4 • Print Settings
DARKNESS
Print Darkness Set the darkness to the lowest setting that provides good print quality. If you set the
darkness too high, the label image may print unclearly, bar codes may not scan
correctly, the ribbon may burn through, or the printhead may wear prematurely.
If desired, use the FEED Self Test on page 159 to determine the best darkness setting.
Note • The recommended darkness setting for this printer is 5.0.
User menu item:
Main Menu >
SETTINGS
Accepted values:
0.0 to 30.0
Related ZPL command(s):
^MD, ~SD
SGD command used:
print.tone
Printer web page: View and Modify Printer Settings > General Setup >
Darkness
PRINT SPEED
Print Speed Select the speed for printing a label (given in inches per second). Slower print speeds
typically yield better print quality.
Note • The recommended print speed for this printer is 2.0 ips.
User menu item:
Main Menu >
SETTINGS
Accepted values:
2, 3, 4, 5, 6
Related ZPL command(s):
^PR
SGD command used:
media.speed
To Next Page
Loading...