59
Printer Setup and Operation
Adjust and Configure the Printer for Silverline Media
10/7/16 ZT410 RFID Printer for Silverline Media User Guide P1089083-001
Adjust and Configure the Printer for Silverline Media
1. Loosen the two fasteners on the ribbon strip plate.
2. Lower the ribbon strip plate as far down as it will travel, and then re-tighten the screws.
3. Using the printhead pressure adjustment dials, set each barrel to the correct position for
your media, as identified in Table 3.
1
Inside dial
2
Outside dial
To Next Page
Loading...