45
Printer Setup and Operation
Install the Printer Driver and Connect the Printer to the Computer—Ethernet
10/7/16 ZT410 RFID Printer for Silverline Media User Guide P1089083-001
Connect to Your Network through the Printer’s Ethernet Port
If you wish to use a wired print server (Ethernet) connection, you may need to connect the
printer to your computer using one of the other available connections. While the printer is
connected via one of those connections, you would configure the printer to communicate with
your Local Area Network (LAN) through the printer’s wired print server.
For additional information about Zebra print servers, refer to the ZebraNet
Wired and Wireless Print Server User Guide. To download the latest version
of this guide, go to http://www.zebra.com/zt400-info.
To connect the printer to your computer by a wired print server, complete these
steps:
1. Install Zebra Setup Utilities as instructed in Install Zebra Setup Utilities on page 24.
2. Connect the printer to an Ethernet cable that is connected to your network.
The printer attempts to communicate with your network. If it is successful, it fills in your
LAN’s gateway and subnet values and gets an IP address. The printer display will
alternate between the printer’s firmware version and its IP address.
3. Check the display to see if an IP address was assigned to the printer. See IP Address
on page 98 for additional ways to view the IP address.
If the printer’s IP address is... Then...
0.0.0.0
or
000.000.000.000
Continue with Configuring the printer
with your LAN information (if necessary)
on page 46.
any other value Continue with Adding a Printer from the
Zebra Setup Utilities Screen on page 47.
To Next Page
Loading...