Zebra Silverline ZT410 - Page 19

19
Introduction
Control Panel
10/7/16 ZT410 RFID Printer for Silverline Media User Guide P1089083-001
User Menus The following are the user menus and the items that appear in each. Click any
of the menu items to go to their descriptions.
Figure 6 • User Menus
NETWORK
— ACTIVE PRINT SERVER
— PRIMARY NETWORK
— WIRED IP ADDRESS
— WIRED SUBNET MASK
— WIRED GATEWAY
— WIRED IP PROTOCOL
— WIRED MAC ADDRESS
— IP PORT
— IP ALTERNATE PORT
— WLAN IP ADDRESS
— WLAN SUBNET MASK
— WLAN GATEWAY
— WLAN IP PROTOCOL
— WLAN MAC ADDRESS
— ESSID
— CHANNEL
— SIGNAL
— PRINT INFORMATION
— RESET NETWORK
— LOAD DEFAULTS
— RFID MENU*
RFID
— RFID COUNTRY CODE
— RFID STATUS
— RFID CALIBRATE
— READ RFID DATA
— RFID TEST
— RFID PROGRAM POS.
— RFID ANTENNA
— RFID READ POWER
— RFID WRITE POWER
— RFID VALID COUNT
— RFID VOID COUNT
— LANGUAGE MENU*
TOOLS
— PRINT INFORMATION
— LCD CONTRAST
— IDLE DISPLAY
— POWER UP ACTION
— HEAD CLOSE ACTION
— HEAD OPEN LIGHT
— COVER OPEN LIGHT
— LOAD DEFAULTS
— MEDIA/RIBBON CAL
— DIAGNOSTIC MODE
— ZBI ENABLED?
— RUN ZBI PROGRAM
— STOP ZBI PROGRAM
— PRINT USB FILE
— COPY USB FILE TO E:
— STORE E: FILE TO USB
— PRINT STATION
— NETWORK MENU*
SETTINGS
— DARKNESS
— PRINT SPEED
— MEDIA TYPE
— PRINT METHOD
— TEAR OFF
— PRINT WIDTH
— PRINT MODE
— LEFT POSITION
— REPRINT MODE
— LABEL LENGTH MAX
— LANGUAGE
— TOOLS MENU*
PORTS
— BAUD RATE
— DATA BITS
— PARITY
— HOST HANDSHAKE
— WML
— BLUETOOTH MENU*
BLUETOOTH
— BLUETOOTH ADDRESS
— MODE
— DISCOVERY
— CONNECTED
— BT SPEC VERSION
— MIN SECURITY MODE
— SETTINGS MENU*
SENSORS
— SENSOR TYPE
— MEDIA/RIBBON CAL
— PRINT INFORMATION
— LABEL SENSOR
— TAKE LABEL
— PORTS MENU*
LANGUAGE
— LANGUAGE
— ZPL OVERRIDE
— COMMAND CHAR
— CONTROL CHAR
— DELIMITER CHAR
— ZPL MODE
— SENSORS MENU*
* Denotes a shortcut to the next user menu