Zebra Silverline ZT410 - Page 107

107
Printer Configuration and Adjustment
Adjust Printer Settings—RFID Settings
10/7/16 ZT410 RFID Printer for Silverline Media User Guide P1089083-001
RFID PROGRAM POS.
Programming
Position
If the desired programming position (read/write position) is not achieved through RFID
tag calibration, a value may be specified. See the RFID Programming Guide 3 for more
information.
User menu item:
Main Menu >
RFID
Accepted values:
F0 to Fxxx (where xxx is the label length in millimeters
or
999, whichever is less)—The printer feeds the
label forward for the specified distance and then
begins programming.
B0 to B30—The printer backfeeds the label for the
specified distance and then begins programming.
To account for the backfeed, allow empty media
liner to extend out of the front of the printer when
using a backward programming position.
Related ZPL command(s):
^RS
SGD command used:
rfid.position.program
Printer web page: View and Modify Printer Settings > RFID Setup >
PROGRAM POSITION
Table 7 • RFID Settings (Continued)