105
Printer Configuration and Adjustment
Adjust Printer Settings—RFID Settings
10/7/16 ZT410 RFID Printer for Silverline Media User Guide P1089083-001
READ RFID DATA
Read RFID Data Read and return the specified tag data from the RFID tag located over the RFID
antenna. No printer movement occurs while tag data is being read. The printhead can be
open or closed.
User menu item:
Main Menu >
RFID
To read and display the information stored on an RFID
tag:
1. Position the RFID label with its transponder over the
RFID antenna.
2. Use the UP ARROW or DOWN ARROW to select
the type of information that you want read and
displayed.
3. Press RIGHT SELECT to select READ.
The results of the test are shown on the display.
Accepted values:
epc—reads the first 128 bits of EPC data
tid information—reads the first 32 bits of the TID
(Tag ID)
password status—reads the tag’s access and kill
passwords
protocol bits—reads the protocol bits from the
EPC memory banks and converts that value to the
EPC size
memory bank sizes—reads the EPC, TID, and user
memory banks sizes
Related ZPL command(s):
^RF
SGD command used:
rfid.tag.read.content and
rfid.tag.read.execute
Table 7 • RFID Settings (Continued)
To Next Page
Loading...