Zebra Silverline ZT410 - Page 88

Printer Configuration and Adjustment
Adjust Printer Settings—Tool Settings
88
P1089083-001 ZT410 RFID Printer for Silverline Media User Guide 10/7/16
HEAD CLOSE ACTION
Head-Close
Action
Set the action for the printer to take when you close the printhead.
Important • The FEED setting is recommended for this printer, but it causes a
tag to be fed each time the printhead is closed.
User menu item:
Main Menu >
TOOLS
Accepted values:
• CALIBRATE—adjusts sensor levels and thresholds,
determines the label length, and feeds the media to
the next web.
• FEED—feeds the labels to the first registration point.
• LENGTH—determines the label length using current
sensor values, and feeds the media to the next web.
• NO MOTION—tells the printer not to move the
media. You must manually ensure that the web is
positioned correctly, or press feed to position the next
web.
• SHORT CAL—sets the media and web thresholds
without adjusting sensor gain, determines the label
length, and feeds the media to the next web.
Related ZPL command(s):
^MF
SGD command used:
ezpl.head_close_action
Printer web page: View and Modify Printer Settings > Calibration
HEAD OPEN LIGHT
Head-Open Light Set the brightness of the light that turns on when the printhead is open.
User menu item:
Main Menu >
TOOLS
Accepted values:
• HIGH
• MEDIUM
• LOW
• OFF
SGD command used:
device.light.head_open_brightness
Table 5 • Tools (Continued)