111
Printer Configuration and Adjustment
Adjust Printer Settings—Language Settings
10/7/16 ZT410 RFID Printer for Silverline Media User Guide P1089083-001
ZPL OVERRIDE
ZPL Override Enable this menu item to prevent the following ZPL commands from changing the
printer’s current settings:
• ^MM (print mode)
• ^MT (Direct Thermal or Thermal Transfer print method)
• ^MN (media type non-continuous or continuous)
When this menu item is disabled, these commands override the printer’s settings.
User menu item:
Main Menu > LANGUAGE
Accepted values:
• DISABLED
• ENABLED
SGD command used:
zpl.zpl_override
COMMAND CHAR
Command
Character
The format command prefix is a two-digit hex value used as a parameter place marker
in ZPL/ZPL II format instructions. The printer looks for this hex character to indicate
the start of a ZPL/ZPL II format instruction.
Set the format command character to match what is used in your label formats.
Important • You cannot use the same hex value for the format command prefix,
control character, and delimiter characters. The printer must see different
characters to work properly. If you are setting the value through the control
panel, the printer will skip any value that is already in use.
User menu item:
Main Menu >
LANGUAGE
Accepted values: 00 to FF
Related ZPL command(s):
^CC or ~CC
SGD command used: zpl.caret
Printer web page: View and Modify Printer Settings > ZPL Control
Table 8 • Language Settings (Continued)
To Next Page
Loading...