83
Printer Configuration and Adjustment
Adjust Printer Settings—Print Settings
10/7/16 ZT410 RFID Printer for Silverline Media User Guide P1089083-001
LABEL LENGTH MAX
Maximum Label
Length
Set the maximum label length.
User menu item:
Main Menu >
SETTINGS
Accepted values:
0 to the maximum label length supported by the printer
Important • Specify a value that is at least 1.0 in.
(25.4 mm) greater than the actual label length
plus the interlabel gap. If you set the value to one
that is smaller than the label length, the printer
assumes that continuous media is loaded, and the
printer cannot calibrate.
The maximum label length recommended for
this printer is 5 in.
Related ZPL command(s):
^ML
SGD command used:
ezpl.label_length_max
Printer web page: View and Modify Printer Settings > Media Setup >
Maximum Length
Table 4 • Print Settings (Continued)
2
1
Label length (including interlabel gap)
2
Interlabel gap
3
Set the maximum label length to
approximately this value
1
3
To Next Page
Loading...