91
Printer Configuration and Adjustment
Adjust Printer Settings—Tool Settings
10/7/16 ZT410 RFID Printer for Silverline Media User Guide P1089083-001
MEDIA/RIBBON CAL
Media and
Ribbon Sensor
Calibration
Calibrate the printer to adjust the sensitivity of the media and ribbon sensors.
For complete instructions on how to perform a calibration procedure, see Calibrate the
Ribbon and Media Sensors on page 121.
User menu item:
Main Menu >
TOOLS
Main Menu >
SENSORS
Related ZPL command(s):
~JC
SGD command used:
ezpl.manual_calibration
Control panel key(s):
Hold
PAUSE + FEED + CANCEL for 2 seconds to
initiate calibration.
Printer web page:
The calibration procedure cannot be initiated through the
web pages. See the following web page for settings that
are set during sensor calibration:
View and Modify Printer Settings > Calibration
Important • Do not change these settings unless
you are told to do so by Zebra Technical Support
or by an authorized service technician.
Table 5 • Tools (Continued)
To Next Page
Loading...