79
Printer Configuration and Adjustment
Adjust Printer Settings—Print Settings
10/7/16 ZT410 RFID Printer for Silverline Media User Guide P1089083-001
TEAR OFF
Tear-Off Position If necessary, adjust the position of the media over the tear-off bar after printing.
User menu item:
Main Menu >
SETTINGS
Accepted values:
–120 to 120
• Higher numbers move the media out (the tear line
moves closer to the leading edge of the next label).
• Lower numbers move the media in (the tear line
moves closer to the edge of the label just printed).
Related ZPL command(s):
~TA
SGD command used:
ezpl.tear_off
Printer web page: View and Modify Printer Settings > General Setup >
Tear Off
Table 4 • Print Settings (Continued)
1
2
1
Media direction
2
Factory-set tear line location at
position 000
To Next Page
Loading...