Zenith L30W36 - Turning on the Monitor

22
Turning on the Monitor
3
2
1
2
1
- When using the remote control, aim it at the sensor on the Monitor.
Turning on the Monitor just after installation
Turning on the Monitor (power cord is still connected)
Connect power cord correctly.
Press the main ON OFF button on the Monitor. At this moment, the Monitor is
switched to standby mode. Press the or INPUT SELECT button on the
Monitor or press the POWER or INPUT SELECT button on the remote control
to turn the Monitor on.
• Press the or INPUT SELECT button on the Monitor or press the
POWER or INPUT SELECT button on the remote control and then the
Monitor will turn on.
If the Monitor is turned off with the remote control button.
• Press the main ON OFF button on the Monitor to turn it on.
If the Monitor is turned off with the ON OFF button on the Monitor
• Press the main ON OFF button on the Monitor and then press the or
INPUT SELECT button on the Monitor or press the POWER or INPUT
SELECT button on the remote control to turn the Monitor on.
If the Monitor is turned off with the remote control and also the ON OFF
button on the Monitor
Tip
• Adjusting volume level
The volume (GG) button increases the sound level and the volume (FF) button
decreases the sound level.