Zero SR/S User Manual

30-38 Controller
Motor and Drive System
30
22. Use a scissor jack to raise the controller. Align
the busbar radsocks with the power pack
radsock connections. If the radsocks are
aligned properly, they will insert with ease. The
key to proper alignment is making sure the
controller assembly is parallel to the power
pack.
23. Note: Once the controller carrier bolt holes are
aligned with the power pack side plates,
loosely start one bolt at a time. This will allow
adjustability for each of the additional bolts.
Additional Note: Installing the front bolts may
require lifting with force.
24. Install bolts (x2) securing controller carrier to
power pack, left side. Tool: T25. Torque: 3 lb-ft
(4 Nm).
25. Install bolts (x2) securing controller carrier to
power pack, right side. Tool: T25. Torque:
3lb-ft (4 Nm).
26. After finishing the controller installation,
contact Zero Motorcycles Customer Service
for assistance for updating the firmware.
• North America:
support@zeromotorcycles.com
• Zero Motorcycles Europe:
service.eu@zeromotorcycles.com

Zero SR/S Specifications

General

Category	Motorcycle
Peak Power	110 hp (82 kW)
Continuous Power	54 hp (40 kW)
Torque	140 ft-lb (190 Nm)
Range (City)	161 miles (259 km)
Range (with Power Tank)	200 miles (322 km)
Top Speed (Max)	124 mph (200 km/h)
Top Speed (Sustained)	110 mph (177 km/h)
Front Tire	120/70 ZR17
Rear Tire	180/55 ZR17
Motor	Z-Force 75-10
Battery	ZF14.4 Lithium-ion
Range (Highway)	82 miles (132 km) at 70 mph
Seat Height	787 mm (30.9 in)
Wheelbase	1, 450 mm (57.1 in)
Front Suspension	Showa 41 mm
Rear Suspension	Showa 40mm piston, piggy-back reservoir shock
Front Brake	Dual J-Juan asymmetric piston calipers, 320 x 5 mm discs
Rear Brake	J-Juan single piston floating caliper with 240mm disc
ABS	Bosch Gen 9
Charging Time (Standard)	4.5 hours