Motor and Drive System
Controller 30-37
30
17. Use a double loop cable tie to anchor the 8-pin
harness connector to the loop on the
controller.
18. Start by looping the cable tie end through the
8-pin connector tab and then through the first
hole in the body of the double loop cable tie.
19. For the second pass, loop the cable tie end
through the anchor point on the controller (to
the rear of the 35-pin controller signal harness
connector) and then through the second hole
in the body of the double loop cable tie.
20. DO NOT PINCH SIGNAL HARNESS OR
PHASE WIRES WHILE INSTALLING THE
CONTROLLER! Pay close attention to the
placement of the cables during the entire
installation process.
21. The controller must be installed parallel to the
power pack. If necessary, use a shim to
position the controller parallel to the Power
Pack.
To Next Page
Loading...
