40-2 Wheel Speed Sensor (WSS)
Suspension
40
8. Remove bolts (x2) securing left side of front
closeout panel to frame. Tool: T25. Torque:
3.5 lb-ft (5 Nm).
Note: Protect rear portion of front fender and
front closeout panel surfaces to reduce the
possibility of scratching their surfaces.
9. Remove bolts (x2) securing right side of front
closeout panel to frame. Tool: T25. Torque:
3.5 lb-ft (5 Nm).
10. Disconnect the front WSS harness connector.
11. Cut cable tie securing the motor stop switch
harness, brake switch electrical harness,
throttle harness, and front wheel speed sensor
to hela bracket harness anchor.
Note: Replace cable tie during the installation
process.
12. Release plastic clip retaining the WSS harness
to front brake hose.
13. Remove bolt securing the WSS harness
cushion clamp and front brake hose. Tool:
T30. Torque: 5 lb-ft (7 Nm).
To Next Page
Loading...
