Zero SR/S

60-8 Body
Body
60
12. Cut cable tie securing the throttle electrical
harness connector to the motor stop switch
electrical connector.
Note: Replace cable tie during the installation
process.
13. Disconnect the throttle electrical harness
connector.
14. Disconnect the motor stop switch electrical
harness connector.
15. Disconnect the headlight switch electrical
harness connector.
16. Disconnect the mode switch electrical
harness connector.
17. Remove bolts (x2) securing the left side of the
hela bracket to the frame head tube. Tool:
T30. Torque: 8 lb-ft (11 Nm).