Maintenance and Safety
Motor Commissioning 10-13
10
21. Reconnect the computer and click
“CONFIGURE” tab.
22. Take note the value in the “Offset” box.
A. If the offset angle is 0 degrees when first
started up, commission the motor.
Note: If it remains at 0 degrees, contact Zero
Motorcycles Customer Service department for
assistance.
•
North America:
support@zeromotorcycles.com
•
Zero Motorcycles Europe:
service.eu@zeromotorcycles.com
B. If encoder/controller/motor were not
touched, then the offset should be ~0.5
degree change due to thermal shift.
23. Take note of the “Offset” again, then
commission a second time by repeating the
procedure. Make sure that the offset
difference is less than ~0.5 degrees.
Note: if commissioning timed out, cycle the
key OFF and back ON again.
CAUTION: If the offset is more than ~0.5
degrees, DO NOT RIDE THE
MOTORCYCLE. Contact Zero Motorcycles
Customer Service department for
assistance.
• North America:
support@zeromotorcycles.com
• Zero Motorcycles Europe:
service.eu@zeromotorcycles.com
To Next Page
Loading...
