10-12 Motor Commissioning
Maintenance and Safety
10
14. Take note the “Offset” (if you have not
updated the firmware prior).
15. Click “ENCODER” tab.
16. Click “COMMISSION” button.
Note: If the COMMISSION button has greyed
out, cycle the key OFF and then back ON again
and navigate back to the COMMISION button.
17. Wait until the commission has finished.
18. Turn key to the OFF position.
19. Turn the key to the ON position.
20. Test the throttle.
Note: Roll throttle to max speed and confirm
full throttle control and smooth operation.
To Next Page
Loading...
