25-18 Chargers
Charging System
25
Removal
1. PERFORM LOCKOUT PROCEDURE: See
Lockout Procedure, page 10.1.
2. Remove high voltage DCDC and CONT fuses.
See High Voltage Fuses, page 70.1.
3. Unbolt the negative battery terminal eyelet.
Cover eyelet with insulating material. Use
cable tie to secure negative battery wire to the
positive battery cable. See 12 Volt Battery
(Disconnect), page 70.3.
CAUTION: Cover/protect battery terminal
eyelet to reduce the risk of accidentally
contacting the negative battery terminal,
which can inadvertently power up the
12 volt system and damage components.
CAUTION: Secure battery terminal wire to
reduce the risk of arcing and damaging
electrical components.
4. Remove headlight upper fairing. See
Headlight Upper Fairing, page 60.2.
5. Remove left and right outer side fairings. See
Side Fairings (Outer), page 60.14.
6. Remove left and right inner side fairings. See
Side Fairings (Inner), page 60.19.
7. Remove tank assembly. See Tank Removal,
page 60.10.
8. Remove charger. See 3KW Rapid Charger
(Front) [Before 2022MY], page 25.1. See 6KW
Charger [22MY Onwards], page 25.14.
9. Remove bolt securing charge inlet ground
wire eyelet. Tool: T30. Torque: 5 lb-ft (7 Nm).
Note: Take note of all ground wire eyelets for
quantity and order so they can be reinstalled
properly upon reassembly.
10. Cut cable tie securing charge inlet harness to
main harness.
Note: Replace cable tie during the installation
process.
To Next Page
Loading...
