54
DRIVING OPERATION
FH12N075
DIESEL PARTICLE FILTER – SYSTEM FAILURES SIGNALIZATION
Failures in diesel particle system failure are signalized by a red control lighting up on
the dashboard with engine running and subsequently by an acoustic signal.
If the failure is not removed, it is signalized with any following starting of the engine
The code of failure us displayed on a display (1) of the displaying unit which is
accessible after removing the right cover of the steering console.
The failures are displayed on display (1) in a form of E: double-figured code of failure
For example: E:36, number 36 representing the code of failure
If failure is not signalized, operation data of diesel particle filter system are displayed
on the display.
The acoustic signal can be turned off by the button (2). If the failure has not been
removed, the acoustic signal is active with repeated staring of the engine and can be
turned off again by the button (2).
If the key is in switchbox in “I” position and the engine is not started, approximately
ten minutes later the diesel particle filter system starts signalizing a failure. Switch the
key to “0” position and start the engine. The code of failure on the display E:32 or
E:33.
DIESEL PARTICLE FILTER FAILURE
CODES
Failure
code E:
Operator´s activity
11, 12, 21,
22, 23, 31,
34, 35, 37,
38, 41, 42,
51, 52, 61,
62
The tractor can be worked
without any limitations,
after terminating your
work, contact authorized
service and report the
code of failure.
32, 33, Switch the key to “0”
position and start the
engine.
36 Regenerate diesel particle
filter
To Next Page
Loading...
