ZIV SWT - Technical Specifications; Switch Characteristics; Unit Interfaces

SWT
GIGABIT/FAST ETHERNET SWITCH TYPE SWT 11/137
USER GUIDE - M0SWTA1903Iv09 - V09 March 2019
1.4 TECHNICAL SPECIFICATIONS
1.4.1 Switch characteristics
➢ Full Duplex Wired Speed switching core.
➢ Port speed automatic detection.
➢ STP and RSTP for resolving loops in the network and operation in rings.
➢ Multiple VLANs management (250 simultaneously).
➢ QoS:
•
the SWT can use the priority fields included in the IEEE 802.1p tag,
•
as well as the DSCP identifier included in the IP header.
➢ Broadcast and Multicast (Broadcast Storm Control) traffic limitation.
➢ MAC access control lists and 802.1x user authentication.
➢ Q-in-Q operation (double-tagged).
➢ Link aggregation by LAG function, static, according to IEEE 802.1ad.
➢ Port mirroring.
➢ Links in VLAN Native mode.
➢ Interoperability with IEDs (Intelligent Electronic Device) that complies with the
IEC 61850 requirements.
1.4.2 Unit interfaces
➢ Up to 32 ports, front or rear.
The chassis has a mechanical structure
of up to four blocks
for the installation of the
ports. The type of blocks to be combined are the following:
•
Block of
8
ports type
10/100Base-Tx
with
RJ-45
connector.
•
Block of
8
ports type
10/100Base-Tx
with
RJ-45
connector and
PoE
in the first four
ports (always front). One block of this type as maximum.
•
Block of
4
or
8
ports type
100Base-Fx multimode
(1300 nm) with
MT-RJ
connector.
•
Block of
2
or
4
ports type
100Base-Fx multimode
(1300 nm) with
ST
connector.