SWT
GIGABIT/FAST ETHERNET SWITCH TYPE SWT 63/137
USER GUIDE - M0SWTA1903Iv09 - V09 March 2019
FIGURE 34 Example of configuration of LLDP menu
5.10 SNMP CONFIGURATION
The equipment has an SNMP agent with the capacity to generate spontaneous messages
to control equipment, based on that protocol.
The agent admits the emitting of messages based on the SNMPv1 [1], SNMPv2c [2] and
SNMPv3 protocol, and the selection of the type of message, trap and inform.
Changes made to the SNMP agent configuration will only be active after RESETTING
the equipment. The Apply command is not sufficient, and so the changes must
previously be saved using the Save command before requesting the reboot.
The configuration parameters are:
SNMP:
• Enable: Enables/disables the execution of the SNMP agent. The agent is operative
when the option is selected.
• Community: Parameter associated with SNMPv1/v2c. Tabulate information that
allows several operating profiles to be defined, including the rights of access
(Access) associated with each one, read only rights (ro) or reading/writing rights
(rw). The profiles are called communities.
To Next Page
Loading...
