SWT
GIGABIT/FAST ETHERNET SWITCH TYPE SWT 102/137
USER GUIDE - M0SWTA1903Iv09 - V09 March 2019
APPENDIX B
DATA STRUCTURE IN CLI
This appendix contains all the information required to use the CLI user console. It explains
the access methods, commands available on the console and gives a step-by-step
example of how to obtain information on the status and configuration of the equipment.
Conventions:
The equipment configuration parameters are laid out in a tree directory, in which
parameters and related subdirectories are grouped, where:
• A name followed by “/” indicates the name of a directory. E.g. Main/
• A name followed by “[]/” indicates a parameter with a matrix structure, as it
contains several attributes. E.g. nat[]/
• A name with nothing after it is a parameter in itself. E.g. action
B.1 ACCESS METHODS
There are two ways of accessing the equipment through the CLI user console:
in the local mode, through the serial port (SRV port).
in local and remote mode, through Telnet.
To Next Page
Loading...
