SWT
GIGABIT/FAST ETHERNET SWITCH TYPE SWT 134/137
USER GUIDE - M0SWTA1903Iv09 - V09 March 2019
B.4 CERTIFICATE INSTALLATION FOR HTTPS MANAGEMENT
The server integrated in the equipment supports the HTTP and the HTTPS protocols, in the
last case being necessary the installation of certificates.
The procedure for loading the certificates for HTTPS management, once the certificate,
the private key and the password of the last one have been got, is the following:
1- Access the configuration section of the web interface, through the SRV port
(“cd /admin/web”)
2- Load in “cert” a valid certificate with the command “upload cert raw”.
The procedure for loading the certificate is the following. Copy in the clipboard the
certificate. Then, execute the indicated upload command and, when it is in wait
period, paste the data from the clipboard. Wait approximately 30s. When the
time is elapsed, the data are shown.
3- Load in “privatekey” a valid private key with the command “upload privatekey
raw”.
The procedure is the same that the one indicated previously for the certificate.
4- Introduce the password of the private key in “privatekeypwd” with the command
“set privatekeypwd”.
Confirmation of the password is required twice as much.
5- In the equipment, activate the access by means of HTTPS
(“set https on”)
6- Apply the changes
(“apply”)
7- Save the new data (optional)
(“save”)
To Next Page
Loading...
