SWT
GIGABIT/FAST ETHERNET SWITCH TYPE SWT 80/137
USER GUIDE - M0SWTA1903Iv09 - V09 March 2019
TACACS+:
TACACS+ (Terminal Access Controller Access Control System) is a remote
authentication protocol used to manage access to servers and communication devices; it
provides separate authentication, authorisation and registration services.
The general configuration parameters are the following:
• 1 Server IP. This sets the IP address of the primary TACACS+ server.
• 2 Server IP. This sets the IP address of the secondary TACACS+ server.
• Encrypted. This permits user to select whether the equipment communication with
the TACACS+ servers must be made in the ciphered mode or not.
• Secret Shared Key. This sets the code to be used for ciphering the communication
when the encrypted option is active.
• Guest Privilege Level. This sets the privilege level (0 to 15) in the request to the
TACACS+ server to gain access as guest user (guest). The privilege level must be
consistent with the one configured in the TACACS+ server queried.
• Admin Privilege Level. This sets the privilege level (0 to 15) in the request to the
TACACS+ server to gain access as administrator user (admin). The privilege level
must be consistent with the one configured in the TACACS+ server queried.
RADIUS:
The parameters for the RADIUS client are the following:
• 1 Server IP. It sets the primary RADIUS server IP address.
• 2 Server IP. It sets the secondary RADIUS server IP address.
• UDP Port. It sets the UDP port in which the RADIUS servers operate. The default
value set the UDP port reserved for the said protocol.
• Shared Secret. It sets the shared secret key. Being a necessary data, the device
uses ziv12345 as the default value.
• Timeout. It sets the timeout for obtaining response from the server. This parameter
is necessary due to the use of the connectionless UDP protocol.
To Next Page
Loading...
