zmorph3d.com 33
Select the prepared Gcode
is not visible on the list press
the up/ down arrow buttons to
Exiting the folder is done by
selecting the folder icon.
CANCEL NEXT
CANCEL NEXT
CANCEL NEXT
example.gcode example.gcode example.gcode
‘NEXT’.
SET’.
X Y Z
MOVE ZMOVE X Y
BACK SET
Enter the ‘SETTINGS’ section. Turn ‘ON’ your Spindle. Go to the ‘’ section.
NOTE
NOTE
The movement in the X and Y axes will be disabled until they
are homed. It is a safety procedure, to protect the machine
against damage.
The movement in the Z axis is avaliable all the time. Use it
to move the milling cutter above the surface height of the
prepared material.
calibrated to the mounted material on the worktable. Skipping
the calibration process may result in damaging the milling
cutter, machine or the toolhead and after that hurting the
user.
CANCEL NEXT
example.gcode
SPINDLE
JOB SPEED
ON OFF
BACK
CALIBRATE SETTINGSCHOOSE
FILE
STARTBACK
CALIBRATE SETTINGSCHOOSE
FILE
STARTBACK
CNC milling
10mm 1mm
To Next Page
Loading...
