Zodiac pH Link - Default Chapter; Table of Contents

3
CONTENTS
❶ Specicaons 5
1.1 I Package contents 5
1.2 I Technical specicaons 7
❷ Installing the chlorinator 8
2.1 I Installing the cell 8
2.2 I Installing the temperature sensor 9
2.3 I Installing the ow switch (chlorinator only without pH Link or Dual Link modules) 9
2.4 I Installing the control box 10
2.5 I Electrical connecons 11
❸ Installing a pH Link or Dual Link module 18
3.1 I Installing the module 18
3.2 I Installing the POD kit 19
3.3 I Installing the ow switch on the POD kit 22
3.4 I Installing the sensors on the POD kit 23
3.5 I Installing the pH minus injecon and sucon hoses 24
❹ Preparing the pool 26
4.1 I Filtraon and lter media 26
4.2 I Balancing the water 27
4.3 I Adding minerals 28
❺ Use 29
5.1 I User interface 29
5.2 I Conguraon before use 29
5.3 I Calibrang the sensors (if an oponal "pH Link" or "Dual Link" module has been installed) 41
5.4 I Roune use 46
❻❻ Control using the iAquaLink™ app 48
6.1 I Conguring the appliance before rst use 48
❼ Care 50
7.1 I Cleaning the sensors 50
7.2 I Inspecng and cleaning the electrodes 51
7.3 I Washing the pool lter (backwashing) 52
7.4 I Winterising 52
7.5 I Preparing the pool for re-use 52
EN