Zodiac pH Link - Page 40

39
5.2.10 Deleng the programmes
• Press and browse the menu using the buons.
• Press to conrm.
• The programmes will be reset to 00:00.
5.2.11 Use with a ltraon control panel
In this conguraon, the ltraon control panel powers the appliance on and o.
• This connecon mode is not recommended since the appliance has its own internal mers.
• In order to be controlled by a ltraon control panel, the appliance's programmes must be reset, see
"5.2.10 Deleng the programmes".
• Once connected to the ltraon control panel, switch the appliance o and on again.
5.2.12 Slave mode
"Slave" mode transfers control over the chlorinaon funcon to an external controller. The external controller must be
connected to the connecon point on the low-voltage circuit, see “2.5 I Electrical connecons”.
"Boost" and "Low" modes can sll be managed by the controller. However, the appliance's programmes are deacvated.
Chlorine producon is maintained at 100%.
• Connect the external controller to the slave connecon point on the low-voltage circuit, see “2.5 I Electrical
connecons”.
• Press and browse the menu using the buons. Press to conrm.
• Press to exit.
EN