ZXV10 W615 User Manual
24 Confidential and Proprietary Information of ZTE CORPORATION
Parameter Description
WEP Key 1–4 Specifies WEP encryption key value. 64-bit WEP key
corresponds to five ASCII characters or ten
hexadecimal characters. 128-bit WEP key corresponds
to 13 ASCII characters or 26 hexadecimal characters.
WAPI-PSK encryption
i. Select WAPI-PSK as the Authentication Type. The following page is
displayed.
ii. Configure the parameters. Refer to the following table.
Parameter Description
WAPI Key Mode Supports two modes: ASCII and HEX. The default is
ASCII.
WAPI Key Specifies WAPI key value. The range is 8-64
characters.
WAPI-CERT encryption
i. Select WAPI-CERT as the Authentication Type. The following page
is displayed.
To Next Page
Loading...
