Zte ZXV10 W615 - Configuring LED Control

ZXV10 W615 User Manual
Confidential and Proprietary Information of ZTE CORPORATION 67
2. Based on the actual requirement, select or clear Enable MLD Snooping
and Enable MLD Snooping Enhancement. Two parameters are all enabled
by default.
3. Click Submit.
—END OF STEPS—
ConfiguringLEDControl
This section describes how to configure LED control.
Steps
1. Select Application > LED Control. The following page is displayed.
2. Enable or disable the LED function.
3. Click Submit.
—END OF STEPS—