ZXV10 W615 User Manual
14 Confidential and Proprietary Information of ZTE CORPORATION
2. Configure the parameters. For details, refer to “Configuring a Broadband
Connection (Fit AP)”.
Working Mode: supports Bridge mode and Route mode. The default is
Bridge mode.
WAN Type: When IP Version is IPv4, the supported modes are DHCP,
Static, and PPPoE. When IP version is IPv6 or IPv4/v6, the supported
modes are DHCP and PPPoE. The default mode is DHCP.
3. Click Submit.
Notes:
The configuration on this page takes effect after the device is restarted.
—END OF STEPS—
WLANConfiguration
Setting Basic Information
This section describes how to set WLAN information for the ZXV10 W615.
Context
Two network cards are available. You can set the cards respectively.
To Next Page
Loading...
