Confidential and Proprietary Information of ZTE CORPORATION 68
C h a p t e r 7
Management Configuration
ManagingSNMPv1/v2c
This section describes how to configure SNMPv1/v2c management.
Steps
1. Select Administration > SNMPv1/v2c. The following page is displayed.
2. Configure the parameters. Refer to the following table.
Parameter Description
Enable SNMP Enables or disables the SNMP function. The
default value is enabled.
Trap Server IP Enter the IP address of the Trap server, for
example, 192.168.1.1.
Trap Server2 IP Enter the IP address of the standby Trap server.
To Next Page
Loading...
