Zte ZXV10 W615 - Setting a Device Name (Fat AP)

ZXV10 W615 User Manual
Confidential and Proprietary Information of ZTE CORPORATION 57
2. Configure the parameters. Refer to the following table.
Parameter Description
Enable Enable or disable the UPnP function. It is disabled by
default.
WAN Connection Select IGD.WD1.WCD1.WCIP1 or empty. The
default value is empty, meaning any values.
Advertisement Period (in
minutes)
Set the corresponding advertisement time as
required. The unit is minute.
Advertisement Time to Live
(in hops)
Set the corresponding time to live (hop count) as
required.
3. Click Submit.
—END OF STEPS—
SettingaDeviceName(FatAP)
This section describes how to set a device name.
Steps
The AP mode of the device is Fat.
1. Set the domain name.
i. Select Application > DNS Service > Domain Name. The following page
is displayed.
ii. In the Domain Name text box, enter the corresponding domain name,
such as ZTE.
iii. Click Submit.